dicklaxt
03-23-2001, 02:27 PM
I don't know who it was that left the tip about this but it was an outstanding piece of engineering.
I purchased a 2'sq.piece of manetic sign material for $14 from a local sign shop.
I cut sheets for the front and rear of the table and drilled holes in the material to go around the protrusions and then slit material so I could install it.I used two pieces on the rear and overlapped them by 3 inches,slid them in from the top and bottom and now the dust collector on the TS is working about 99% efficient.I still have about 2'X 8" left over I think I'll use that on the wife's purse latch while she is sleeping,my rat hole money is running low.
Thanks again to whom ever.....Dick
I purchased a 2'sq.piece of manetic sign material for $14 from a local sign shop.
I cut sheets for the front and rear of the table and drilled holes in the material to go around the protrusions and then slit material so I could install it.I used two pieces on the rear and overlapped them by 3 inches,slid them in from the top and bottom and now the dust collector on the TS is working about 99% efficient.I still have about 2'X 8" left over I think I'll use that on the wife's purse latch while she is sleeping,my rat hole money is running low.
Thanks again to whom ever.....Dick