View Full Version : Corner finishing
Guest Inquirer
03-27-2001, 06:31 PM
I am finishing my corners and would like to know if I can use something other than filing. Is there something that I can get to power through the corner finishing? Please advise.
Woodchuck
WoodMangler
03-27-2001, 08:07 PM
you are finishing the corners of a ??? and it's made of ??? and the type of finish you want is ???
Need more info eh....
Marc
Sonny Edmonds
03-28-2001, 03:31 PM
...and is it inside corners??? Outside corners??? Square corners??? Rounded corners??? Street corners or country curves???
Sorry, I just had to fart around, too. }>
Sonny
WoodMangler
03-28-2001, 04:50 PM
like Ms. Doubtfire said..."looks like it was a drive-by fruiting!"
hope you saw that movie...otherwise I got to explain...
Marc
Lou_williams
03-28-2001, 04:59 PM
Marc,
Thanks for the laugh.
Sonny Edmonds
03-28-2001, 05:28 PM
Loved It!
Laugh till you cry and cry till you laughed agian.
Sonny
Roger S. Dillman
03-28-2001, 11:39 PM
The easiest treatment for finishing corners is with a round over-router bit. There are many diameters,the most common is 3/8". You can get away with using a flush trimming router. If there is enough clearance,you usually can do all edges of a project,after
its assembled.
WoodMangler
03-29-2001, 12:12 AM
What kind of corner?...mitered?...inside?...coped?...see, that's why nobody answered...cause nobody knew what kind of corner. Hope it aint a mitered corner on a box...gonna look real bad after attacking it with a router eh?
Marc