View Full Version : Starrett calipers and combination square for sale
cracker
12-07-2003, 11:48 AM
Monty what is your email address?
Monty
12-07-2003, 11:52 AM
See the little "envelope, pen and paper" icon just below the date? That will give you my email address.
Monty
Measure with a micrometer, mark with chalk, cut with an axe.
cracker
12-07-2003, 12:28 PM
Monty, I've tried several times and it does not work for me, if it will work for you then send me an email
Everette
Monty
12-07-2003, 02:19 PM
Since it does'nt seem to be working for you, I'll go ahead post it incase others have had trouble. It's mcsjez@ev1.net.
Monty
Measure with a micrometer, mark with chalk, cut with an axe.
Monty
06-02-2010, 09:21 AM
If you’ve read some of my past posts, you know that I have inherited a lot of machinists tools from my FIL. I have a 12 inch Starrett rule with a center head (not labeled) and a protractor head (labeled Starrett), (sorry it does not have a square head with it) and lots of Starrett calipers that I thought I would offer for sale here before I put them on Ebay.
I would like $20.00 plus shipping for the Starrett rule set. A new set would run about $100.00.
I have both flat and round calipers like these in sizes from 2 to 8 inches, and some large friction joint calipers and some combination caliper dividers. I would like between $5 and $15 each depending on size (too many to list and give individual prices).
If you are interested, please email me for more info and prices. Whatever is left at the end of this week will go on Ebay.
Monty
Measure with a micrometer, mark with chalk, cut with an axe.