I remember seeing plans for a horizontal mortiser in an issue of shopnotes a couple of years ago, but I can't seem to find it anywhere. I also remember seeing someone on this forum had actually built it (and posted a pic of it in their shop). I was wondering who that was, what they thought of it after using it for a while, and if anyone could point me to the issue, or where to get the plan online. Searching around plans now only shows this
http://www.plansnow.com/dn3081.html

and that's different from what I remember. In the plans I'm thinking of, the router was held horizontally, and the level of the table was set by two diagnal ramps.

Any ideas?

Thanks,
Mat

"Use the talents you possess, for the woods would be very silent if no birds sang except the best." - Henry Van Dyke