1. 1/4 Horsepower Emerson motor,Dual Shaft,115/230Volt,1725
RPM **
2. 3 conductor #14 gauge line cord,15' long
3. Vacuum gauge,0-30" Hg,2" Face
4. Vacuum pump "Muffler"
5. Pulleys for 1/2" shaft of Vac Pump & Mtr
6. Debris and Moisture Filter for vacuum line
7. Needle Valve with knob and bleed filter

** Heres a note of monetary importance this motor is new purchased for used cost.......$24.99 ,,,,,,,,,don't know if it was an oops or used were not in stock. My gain,becuse relacement cost(thiers) and two way shipping(thiers) makes it a swap out,,,,,,,,,,Hope to get all this assembled tomorrow.Then off to find some reinforced vacuum hose & fittings and a drive v-belt.I got to also check and rewire motor for 115 volt if needed. We are getting there, I'm having a friend ( metal worker) make me a replacement "Swivel Adaptor" to replace the one I made(his is a much better design),this will make system "Jam Up and Jelly Tight"








Dickie
A joker in the deck of life