outfeed table for Jet ProShop table saw

[lgsmith]

Has anyone come up with a good design for an out-feed table for Jet ProShop hybrid table saw? No sense redesigning the wheel if someone has a good way to attach a bracket to the back of the saw without interfering with the fence guide.

Thanks.
LG Smith

[hcbph]

If you're looking for a suggestion, that back end looks alot like many Biesemeyer clones I've seen and used. When I got my current saw, I wanted that back open but the fence had a foot like that on it. I found a piece of plastic cutting board that was close and shaved it down so it just fit under the fence filling the gap between the bottom of the fence and the table. Cut it down to size, epoxied it to the bottom of the fence. Once that was changed out you have the entire back side of the saw (including the angle iron from the fence) to mount your outfeed table to.

That's what I've done on the last 2 saws I've owned and had no problems with it in the 10-15 years I've been doing it.