View Poll Results: Do you own a Radial Arm Saw ?

Voters
9. You may not vote on this poll

  • Yes, I own a Radial Arm Saw

    7 77.78%

  • No, I do not own a Radial Arm Saw

    2 22.22%
Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Radial Arm saw

  1. 07-14-2012, 12:25 PM #11
    SawSucker
    SawSucker is offline
    Member
    Join Date
    Sep 2010
    Location
    North Dakota
    Posts
    76
    Lots of interesting reading there Frank. I like the jig you built too, makes alot of sense.
    Reply With Quote Reply With Quote
  2. 07-14-2012, 09:19 PM #12
    SawSucker
    SawSucker is offline
    Member
    Join Date
    Sep 2010
    Location
    North Dakota
    Posts
    76
    One more question, if you look at the Radial Arm Saw that I bought you will notice that the arm does not pivot at the back of the arm, it has a second arm that pivots midway out. If I remember correctly one of the older DeWalts had the same type of setup. Anyone see any advantages or disadvantages in that design ?
    Reply With Quote Reply With Quote
  3. 07-26-2012, 06:39 PM #13
    grampyrichard
    grampyrichard is offline
    Member
    Join Date
    Jul 2012
    Location
    Billerica, MA
    Posts
    1
    I have a Craftsman Radial it was my main saw and moulder until I bought up. Now it has become a catch all. I do still use it to cut lumber to rough length, then finish off on either table or miter saw. I don't think I would give it up.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules