|
Angles to Cut Octagonal Pieces
|
I'm going to make an octagonal lighthouse and I'm trying to figure out the angle to cut the pieces.
Scott Noyes:
The glue-up angle for each piece is 67.5 degrees. The formula for the
interior angles of a regular polygon is A (angle) = 180 - (360/n),
where n is the number of sides. Hence, the interior angles of an
octagon are 135 degrees each. (360 divided by eight is 45. Subtract 45
from 180, and you get 135.) However, each interior angle is split in
half to make the two gluing surfaces. For that, you can divide the
angle in half to get 67.5 degrees, or use the formula 90 - (180/n)
which gives the same answer.
John Brock: To
determine the angle, divide the degrees in a circle (360), by the
desired number of pieces (8), and then split the angle in two since
half will be applied to each side of your stock. For an octagon, the
calculated angle is 45 degrees, and 22.5 degrees will be added or
subtracted from each side of the stock. Your table saw normally is set
at 90 degrees, or perpendicular to the top. Subtract the 22.5 degrees
from 90, and you get 67.5 degrees. Set your blade tilt to 67.5.
This article originally appeared in the Woodworker's Journal eZine.
Click here for information on this free, twice monthly online publication.
Copyright; 2010 Woodworker's Journal
All rights reserved. No part of this article may be reproduced in any form or by any electronic or mechanical means, including information storage and retrieval devices or systems, without prior written permission from the publisher.
|