Drilling Holes in Dowel Ends
Drilling holes in the ends of dowel rods is awkward because they're hard to clamp vertically. The answer is to use two handscrews together, as shown below. With this setup you can easily slide your dowel rod around on the drill press table until it is exactly centered under the bit
This article originally appeared in the Woodworker's Journal eZine.
Click here for information on this free, twice monthly online publication.
Copyright; 2010 Woodworker's Journal
All rights reserved. No part of this article may be reproduced in any form or by any electronic or mechanical means, including information storage and retrieval devices or systems, without prior written permission from the publisher.